Item No :HXPH-RARK5KW1
The installation of the heater
It is necessary to prevent the object around the heater from being affected or damaged by high temperature.
Exhaust system
When placing the exhaust port, it is necessary to prevent the exhaust gas from entering the interior of the vehicle through the overcooler, hot air inlet or window.
Combustion of air
Do not draw in the passenger compartment the combustion air used for the combustion of the heater.
Place the air intake should be noted that it can not be blocked by objects.
Heated air inlet
The supplied heated air must consist of fresh air or circulating air and is taken from a clean area.
Protective gates or other suitable tools must be used to protect the intake ducts.
Heated air outlet
When placing hot air pipes in a car, make sure that it is not easy to be touched to prevent injury or damage to the subject.
Exhaust system
When arranging the exhaust pipe, it must be noted that the exhaust pipe outlet must avoid flammable materials, avoid heating or igniting ground combustibles or loading cargo.
W orking e nvironment
1.Applicable ambient temperature:-40℃~40℃
2.Applicable altitude:≤3000 meter
3.Fuel: Must use light diesel oil suitable for the current environment (Note: This machine may not use gasoline fuel)
Safety instructions for installation and operation
The following measures are not allowed
- Change the key components on the heater.
- Use other manufacturer parts without the permission of the Company.
In the installation or operation of the specifications described in violation of the specification.
Only original accessories and original accessories are allowed for installation or maintenance.
Do not allow the use of heaters in the formation of flammable vapors or dust, as in the following facilities:
- fuel warehouse
- carbon storage warehouse
- wood warehouse
- granary and similar locations
The heater must be closed when refueling
If the fuel flows out of the fuel system of the heating equipment (leaked), it should be returned immediately to the service provider for repair.
During the operation of the heater, it is not allowed to stop the heater operation by power failure.
Machine fault code Description:
1. Voltage undervoltage, knob panel flashes once, or E-01 is displayed on the digital panel
How to deal with it: Raise the supply voltage
2. Power overvoltage, knob panel flashes twice, or E-02 is displayed on the digital panel
How to deal with it: Reduce the supply voltage
3. The ignition plug fault, the knob panel light flashes three times, or the digital panel shows E-03
How to deal with it: Check whether the ignition plug is open or shorted
4. The pump is faulty, the knob panel lights flash 4 times, or E-04 is displayed on the digital panel
How to deal with it: Check the car pump is broken, or short circuit
5. The machine housing is overheated, the knob panel lights flash 5 times, or the digital panel shows E-05
How to deal with it: Check the temperature sensor on the housing, or if the fan speed is abnormal
6. Motor copper fault, knob panel lights flash 6 times, or digital panel display E-06
How to deal with it: Check magnet polarity, Hall position
7. Disconnect, the knob panel flashes 7 times, or E-07 is displayed on the digital panel
How to deal with it: Check the panel connection plug, the blue communication line is not connected properly
Warning:
1. Installation, the fixed plate must be kept closed with the car sheet metal, so as not to burn the exhaust through the gap into the cab damage to the driver's body.
2. The length of the exhaust pipe shall not be less than 30 cm.
3. The exhaust outlet must be fixed in the open space.
4. Exhaust pipe outlet is not allowed to travel direction.
Recommendation: After the heater is fixed, it is recommended to use the sealant to seal the installation gap.
EUR
GBP
CAD
AUD
JPY
RUB
KRW
ILS
MXN
CNY